Arduino MATERIA 101 Uživatelský manuál stáhnout pdf (Strana 18)

Assembly Manual

Arduino Materia 101

assEmBlINg ThE caRRIagE

Fig. 1

To complete this step, select these

tools and parts:

— Right lateral shoulder

— Left lateral shoulder

— Stepper motor with pulley

— X axis D8x244mm guide

— LMU88 bearings (8)

— Seeger rings(12)

— Nylon bearing supports (4)

— M3x10 nylon stand-offs (2) and

M3x20 nylon stand-offs (2)

— M3x6 bolts (20)

— X axis metal rod guides (8)

— T2.5 500 belt

— M3x25 bolt

— M3 lock nut

— 12mm 3x6 teflon tube

— End-stops (2)

— M3 x10 bolts (2)

— T2.5 16 pulley

Fig. 2

Take the left shoulder, fasten two

nylon bearing carriers with M3x6

bolts (4). This part must be attached

to the inside of the shoulder.

Fig. 3

If you need to, polish the holes of the

X guide carrier with some sandpaper

to ensure a good connection.

With M3x6 bolts (2) couple and

secure the 4 metal rod guides. If

needed, you may use a D8x315mm

bar to center the metal rod guides

with the shoulder hole before

tightening. After this step, test if

the guide is fully inserted into both

metal rod guides. You can do this by

pushing the second rod guide laterally

with a flathead screwdriver.

This part must not move.

Fig. 1

Fig. 3

Fig. 2

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 54 55

Komentáře k této Příručce

Žádné komentáře

Arduino MATERIA 101 Uživatelský manuál Strana 18

Komentáře k této Příručce