Arduino MATERIA 101 Uživatelský manuál Strana 39

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 55
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 38
39
Assembly Manual
Arduino Materia 101
assEmBlINg ThE fRamE
33
Fig. 30
Fig. 32
Fig. 31
Fig. 33
Fig. 30
Clean the contacts by removing the
rubber protection from the white LED
strip using scissors.
Fig. 31 - 32
Take the bipolar red-black cable
and strip both ends. You need to
solder the cables to the LED strip
respecting the polarity (+red,
-black). You can close off the
contacts with insulating tape.
Remove the adhesive band and
attach the white LED to the frame
inside the front of the printer,
leaving the wiring oriented to the
left (to the display).
Fig. 33 - 34
Take 40 cm of the bipolar cable,
strip the cable ends and cover with
two pieces of the shrink tube. With
the socket, locate the + and - pole
(in the picture you can see the +
Zobrazit stránku 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 54 55

Komentáře k této Příručce

Žádné komentáře